List of Figures
U3606A User’s and Service Guide XIX
List of Figures
Figure 1-1 U3606A handle adjustments 6
Figure 1-2 U3606A stacking directions 8
Figure 1-3 U3606A dimensions 9
Figure 1-4 U3606A front panel 10
Figure 1-5 VFD full display with all segments illuminated 11
Figure 1-6 U3606A keypad with both multimeter and source operations 14
Figure 1-7 U3606A connector terminals 19
Figure 1-8 U3606A rear panel 22
Figure 2-1 Terminal connections for voltage measurements 25
Figure 2-2 Terminal connections for current measurements 29
Figure 2-3 Terminal connections for 2-wire resistance measurements 33
Figure 2-4 Terminal connections for 4-wire resistance measurements 36
Figure 2-5 Terminal connections for frequency, pulse width, and duty cycle
measurements via the voltage path 38
Figure 2-6 Terminal connections for frequency, pulse width, and duty cycle
measurement via the current path 39
Figure 2-7 Terminal connections for capacitance measurements 47
Figure 2-8 Terminal connections for continuity tests 49
Figure 2-9 Terminal connections for diode tests 51
Figure 3-1 Constant voltage mode terminal connections 74
Figure 3-2 Constant current mode terminal connections 76
Figure 3-3 Remote sensing connections 100
Figure 3-4 Local sensing connections 100
Figure 5-1 Test setup for zero offset (short) verification 141
Figure 5-2 Test setup for DC voltage, AC voltage, resistance, and capacitance gain
verification 142
Figure 5-3 Test setup for DC current and AC current gain verification 142
Figure 5-4 Test setup for frequency gain verification 143
Figure 5-5 Test setup for CV programming and readback accuracy
verification 143
Figure 5-6 Test setup for CV load and line regulation verification 144
Figure 5-7 Test setup for CV noise effect verification 144
Figure 5-8 Test setup for load transient response time verification 145
Figure 5-9 Test setup for CC programming and readback accuracy
verification 145
To Next Page
Loading...
Need help?
General
