DC Power Supply Operation 3
Basic Operation
U3606A User’s and Service Guide 75
Supplying constant voltage
1 Press Voltage to select the constant voltage mode. When the U3606A is
operating in constant voltage mode, the CV annunciator on the front
panel is illuminated.
2 The output voltage can be programmed when the output is enabled
(OUT) or disabled (SBY). Ensure that the CV annunciator is flashing.
(Press Voltage again if it is not.)
3 Press or to select which digit position to be changed.
4 Press or to increase or decrease the value.
5 Press Voltage again, Shift > Save, or Shift > Exit to save the changes and
exit the edit mode.
6 Press to regulate the output voltage.
The output voltage is limited by the range selected. Press Shift > Range to
select an appropriate range. You can only select a range when the output
is disabled (the SBY annunciator is illuminated).
To Next Page
Loading...
