Operational Commands
7210 SAS D, E, K OS Quality of Service Guide Page 163
The meter must be created as multipoint. The multipoint designator cannot be defined after the meter is
created. If an attempt is made to modify the command to include the multipoint keyword, an error is
generated and the command will not execute.
The multipoint keyword can be entered in the command line on a pre-existing multipoint meter to edit
meter-id parameters.
Values multipoint or not present
Default Not present (the queue is created as non-multipoint)
meter
Syntax meter meter-id
no meter
Context config>qos>network>ingress>fc
Description
This command overrides the default unicast forwarding type meter mapping for fc fc-name. The
specified meter-id must exist within the policy as a non-multipoint meter before the mapping can
be made. Once the forwarding class mapping is executed, all unicast traffic on a port using this
policy is forwarded using the meter-id.
The no form of this command sets the unicast (point-to-point) meter-id back to the default meter
for the forwarding class (meter 1).
Default meter 1
Parameters meter-id — Specifies the meter-id. The specified parameter must be an existing, non-multipoint meter
defined in the config>qos>network>ingress context.
Values 1 — 12
multicast-meter
Syntax multicast-meter meter-id
no multicast-meter
Context config>qos>network>ingress>fc
Description
This command overrides the default multicast forwarding type meter mapping for fc fc-name. The
specified meter-id must exist within the policy as a multipoint meter before the mapping can be
made. Once the forwarding class mapping is executed, all multicast traffic on a port using this
policy is forwarded using the meter-id.
The no form of the command sets the multicast forwarding type meter-id back to the default meter
for the forwarding class.
Default
9
To Next Page
Loading...
Need help?
General
