Deleting QoS Policies
Page 16 7210 SAS D, E, K OS Quality of Service Guide
Deleting QoS Policies
A slope policy is associated by default with access and access uplink egress pools. A default policy
may be replaced with a non-default policy, but a policy cannot be entirely removed from the
configuration. When a non-default policy is removed, the policy association reverts to the default
slope policy policy-id default. A QoS policy cannot be deleted until it is removed from all ports
where it is applied or if the policies are using the slope-policy.
ALA-7>config>qos# no slope-policy slopePolicy1
MINOR: QOS #1902 Slope policy has references
ALA-7>config>qos#
The following CLI syntax examples can be used to remove slope policies from ports on 7210
SAS-E and 7210 SAS-D:
CLI Syntax:
config>port>access>egress>pool# no slope-policy name
config>port>accesss>uplink>egress>pool# no slope-policy name
The following CLI syntax examples can be used to remove slope policies from ports on 7210
SAS-K:
CLI Syntax:
config> qos> sap-ingress> queue <id> no slope-policy name
config> qos> sap-egress> queue <id> no slope-policy name
config> qos> network> ingress> queue <id> no slope-policy name
config> qos> network-queue> queue <id> no slope-policy name
Remove a Policy from the QoS Configuration
To delete a slope policy, enter the following command:
CLI Syntax: config>qos# no slope-policy policy-id
Example: config>qos# no slope-policy slopePolicy1
To Next Page
Loading...
Need help?
General
