Alcatel-Lucent 7210 SAS Series - Configuration Guidelines for SAP Egress Policy

Service Egress Policies
7210 SAS D, E, K OS Quality of Service Guide Page 389
→ Dot1p and/or IP DSCP marking must be supported on access SAP egress; Provide
support for configuration of per FC Dot1p and/or IP DSCP marking, with the
capability to assign different Dot1p and/or IP DSCP values for in-profile and out-of-
profile packets. In addition, support for marking DEI value is available.
The following displays the SAP egress QoS policy configuration for 7210 SAS-K:
*A:SAH01-071>config>qos>sap-egress# info detail
----------------------------------------------
description "Default SAP egress QoS policy."
scope template
no remarking
remark 1
queue 1 create
adaptation-rule cir closest pir closest
rate cir 0 pir max
mbs 60
cbs 10
slope-policy "default"
priority 1
weight 1
exit
fc af create
queue 1
exit
fc be create
queue 1
exit
fc ef create
queue 1
exit
fc h1 create
queue 1
exit
fc h2 create
queue 1
exit
fc l1 create
queue 1
exit
fc l2 create
queue 1
exit
fc nc create
queue 1
exit
Configuration Guidelines for SAP Egress Policy
• User has an option to configure lesser number of egress queues per SAP. In hardware
queues are allocated in groups of 2 and reserved for use by the SAP even though user
specifies an odd value.