Alcatel-Lucent 7210 SAS Series - Configuration of DSCP and Dot1 P Classification Policies on 7210 SAS-K

Network QoS Policies
7210 SAS D, E, K OS Quality of Service Guide Page 127
Step 1: Match the IP DSCP value in the packet with the value configured in each of the IP DSCP
entry defined in the DSCP classification policy. Assign the FC corresponding to the first
entry which matches with IP DSCP value in the packet. If it is not an IP packet skip this step
(in other words for non-IP packets, perform Step #2 directly).
Step 2: Match the Dot1p value in the packet (if available) with the value configured in each of
the Dot1p entry defined in the Dot1p classification policy. Assign the FC corresponding to
the first entry which matches with Dot1p value in the packet.
Step 3: If no match is found in IP DSCP classification policy and Dot1p classification policy,
assign the default FC.
NOTE: IP and MAC criteria based classification on network ingress is not supported on 7210
SAS-K.