Overview of service ingress policy on 7210 SAS-D and 7210 SAS-E
Page 220 7210 SAS D, E, K OS Quality of Service Guide
Overview of service ingress policy on 7210 SAS-D and
7210 SAS-E
There is one default service ingress policy. The default policy has two classification resources and
one meter (the num-qos-classifiers set to value "2"). Queuing is not supported. Each policy can
have up to 32 ingress meters. The default policies can be copied and modified but they cannot be
deleted. The default policies are identified as policy ID 1.
The default policies are applied to the appropriate interface, by default. For example, the default
SAP ingress policy is applied to access ingress SAPs. You must explicitly associate other QoS
policies. For information about the tasks and commands necessary to access the command line
interface and to configure and maintain your 7210 SAS devices, refer to the CLI Usage chapter in
the 7210 SAS OS Basic System Configuration Guide.
To Next Page
Loading...
Need help?
General
