Alcatel-Lucent 7210 SAS Series - Copying and Overwriting Qos Policies

Slope QoS Policies
7210 SAS D, E, K OS Quality of Service Guide Page 17
Copying and Overwriting QoS Policies
You can copy an existing slope policy, rename it with a new policy ID value, or overwrite an
existing policy ID. The overwrite option must be specified or an error occurs if the destination
policy ID exists.
CLI Syntax: config>qos> copy {slope-policy} source-policy-id dest-policy
id [overwrite]
The following output displays the copied policies for (7210 SAS-E devices):
A:ALA-7>config>qos#slope-policy "default" create
----------------------------------------------
description "Default slope policy."
high-slope
shutdown
start-threshold 75
queue 1 drop-rate 1
queue 2 drop-rate 1
queue 3 drop-rate 1
queue 4 drop-rate 1
queue 5 drop-rate 1
queue 6 drop-rate 1
queue 7 drop-rate 1
queue 8 drop-rate 1
exit
low-slope
shutdown
start-threshold 50
queue 1 drop-rate 0
queue 2 drop-rate 0
queue 3 drop-rate 0
queue 4 drop-rate 0
queue 5 drop-rate 0
queue 6 drop-rate 0
queue 7 drop-rate 0
queue 8 drop-rate 0
exit
----------------------------------------------
A:ALA-7>config>qos#
A:ALA-7>config>qos#slope-policy "slopePolicy1" create
----------------------------------------------
description "Default slope policy."
high-slope
shutdown
start-threshold 75
queue 1 drop-rate 1
queue 2 drop-rate 1
queue 3 drop-rate 1
queue 4 drop-rate 1
queue 5 drop-rate 1
queue 6 drop-rate 1
queue 7 drop-rate 1