QoS Policies
7210 SAS D, E, K OS Quality of Service Guide Page 55
Table 18: Service Ingress QoS Policy IP Match Criteria for 7210 SAS-K
Table 19: Service Ingress QoS Policy IPv6 Match Criteria for 7210 SAS-K
Table 20: Service Ingress QoS Policy MAC Match Criteria for 7210 SAS-K
Note that 7210 SAS-K does not support configuring of the frame-type match criteria and the
default frame type configured is Ethernet - II. See Table 21, Lists the criteria that can be matched
for the various MAC frame types., on page 61
Table 21: Lists the criteria that can be matched for the various MAC frame types.
IP Criteria
• IP DSCP (available for access SAPs in VPLS and
VLL services)
IP DSCP, IP source and mask, IP
destination and mask, IP protocol,
TCP/UDP
source port, TCP/UDP destination
port, fragment.
IPv6 Criteria
• IP DSCP (available for SAPs in VPLS and VLL ser-
vices)
IP DSCP, IPv6 128-bit source and
mask, IPv6 128-bit destination and
mask, IP
protocol/next-header, TCP/UDP
source port, TCP/UDP destination
port.
MAC Criteria
• IEEE 802.1p/Dot1p value/mask, Source MAC
address/mask, Destination MAC address/mask,
EtherType Value/Mask
The MAC match criteria that can be
used for an Ethernet frame depends
on the frame's format.
Note: The default frame type configured is Ethernet - II
Frame Format Description
802.3 IEEE 802.3 Ethernet frame. Only the source MAC, destination MAC and
IEEE 802.1p value are compared for match criteria.
802dot2-llc IEEE 802.3 Ethernet frame with an 802.2 LLC header. Only the source
MAC and destination MAC address are compared for match criteria.
To Next Page
Loading...
Need help?
General
