EasyManuals Logo

Alcatel-Lucent 7210 SAS Series User Manual

Alcatel-Lucent 7210 SAS Series
488 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #268 background imageLoading...
Page #268 background image
Basic Configurations
Page 262 7210 SAS D, E, K OS Quality of Service Guide
Since this FC uses unicast meter and broadcast meter, two entries are needed to identify these
traffic types explicitly, multicast and unknown-unicast traffic use the same resource as the unicast
traffic.
FCl1 = 1 + 0 + 1 + 0 = 2
Since this FC uses unicast meter and broadcast meter, two entries are needed to identify these
traffic types explicitly. multicast and unknown-unicast traffic use the same resource as the unicast
traffic.
FCaf = 1 + 1 + 1 + 0 = 3
Since this FC uses unicast, broadcast and multicast meter, three entries are needed to identify these
traffic types explicitly. Unknown-unicast traffic type is classified using the same entry as multicast
traffic type and uses the same meter.
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Since no explicit meters are configured for FC be, it uses meter 1 for all traffic types and needs one
entry is needed to identify these traffic types.
Using the above equation, the total classification entries used = 12 and meters used = 5. The num-
qos-classifiers can be set to 12 (the minimum value).
If the same policy were to be used for a SAP in an Epipe service, then since all traffic is classified
to a unicast traffic type and since only unicast meters are used, the following results:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 1 + 0 + 0 + 0 = 1
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 0 + 0 + 0 = 1
FCl1 = 1 + 0 + 0 + 0 = 1
FCaf = 1 + 0 + 0 + 0 = 1
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Using the above equation, the total classification entries used = 5 and meters used = 3 (since all
FCs used only meter #1, meter #3 and meter #5). For epipe service a policy with num-qos-
resources set to 6 can be used.
Example 4
sap-ingress 10 create
description“example-policy-3”
num-qos-classifiers 36
meter 1 create
rate cir 100 pir 100
exit

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS Series and is the answer not in the manual?

Alcatel-Lucent 7210 SAS Series Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS Series
CategorySwitch
LanguageEnglish

Related product manuals