Operational Commands
7210 SAS D, E, K OS Quality of Service Guide Page 303
• On 7210 SAS-K, before using IPv4, IPv6 and MAC match criteria, resources must be
allocated using the CLI command config> system> resource-profile>ingress-internal-
tcam> qos-sap-ingress-resource. Please read the Service Ingress Qos Policies Chapter
above and the 7210 Basic Systems Guide for more information about this CLI command
and resource allocation.
• On 7210 SAS-D, E on service ingress only meters are supported.
• On 7210 SAS-K, service ingress only queues with shapers are supported.
The no sap-ingress policy-id command deletes the SAP ingress policy. A policy cannot be deleted until it is
removed from all services where it is applied. The system default SAP ingress policy is a special case; the
no command restores the factory defaults to policy-id 1.
Parameters policy-id — The policy-id uniquely identifies the policy.
Values 1 — 65535
create — Keyword used to create a sap ingress policy.
dot1p-classification
Syntax dot1p-classification policy-id
no dot1p-classification
Context config>qos>sap-ingress
config>qos>network>ingress
Description This command defines a policy to assign the forwarding class to a packet based on the dot1p bits.
When it is defined in a network QoS policy and associated with an access-uplink port, a packet received on
the access-uplink port is used to match with the Dot1p values defined in this policy. If a match is found, then
the corresponding forwarding class and profile is assigned to the packet.
When it is defined in a service ingress QoS policy and associated with an access SAP ingress, a packet
received on the SAP is used to match with the Dot1p values defined in this policy. If a match is found, then
the corresponding forwarding class and profile is assigned to the packet.
The no form of the command disables use of dot1p-classification policy.
Parameters policy-id — The policy-id that uniquely identifies the policy.
Values [1..65535]
To Next Page
Loading...
