Page 356 7210 SAS D, E, K OS Quality of Service Guide
scope of the policy is template. There are 8 queues always available per port for which parameters
are configurable.
Parameters
policy-id — The value that uniquely identifies the access-egress policy.
Values 1 — 65535
create — The keyword used to create an access-egress policy. The create keyword requirement can be
enabled/disabled in the environment>create context.
fc
Syntax fc fc-name [create]
no fc fc-name
Context config>qos>access-egress
Description
This command defines the fc node within the access egress QoS policy is used to contain the
explicitly defined Dot1p marking commands for the fc-name.
Note that when the mapping for the fc-name and marking value is not defined, the node for fc-
name is not displayed in the show configuration or save configuration output.
The no form of the command removes the explicit Dot1p marking commands for the fc-name.
fc-name — Specifies the forwarding class for which Dot1p marking is to be edited. The value given for fc-
name must be one of the predefined forwarding classes in the system.
Values be, l2, af, l1, h2, ef, h1, nc
create — Keyword used to create an access-egress policy. The create keyword requirement can be enabled/
disabled in the environment>create context.
de-mark
Syntax [no] de-mark [force de-value]
Context config> qos> access-egress> fc
config> qos> network> egress> fc
Description
Platforms Supported: 7210 SAS-D only.
This command is used to explicitly define the marking of the DEI bit for fc fc-name according to
the in and out of profile status of the packet (fc-name may be used to identify the dot1p-value).
If no de-value is present, the default values are used for the marking of the DEI bit: for example, 0
for in-profile packets, 1 for out-of-profile ones – see IEEE 802.1ad-2005 standard.
To Next Page
Loading...
