Page 362 7210 SAS D, E, K OS Quality of Service Guide
dscp-in-profile
Syntax dscp-in-profile dscp-name
no dscp-in-profile
Context config>qos>access-egress>fc
Description
Platforms Supported: 7210 SAS-D.
This command specifies the in-profile DSCP name for the forwarding class. When marking is set,
the corresponding DSCP value is used to mark all IP packets with out-of-profile status, on the
egress of this forwarding class queue.
When multiple DSCP names are associated with the forwarding class at network egress, the last
name entered will overwrite the previous value.
The no form of this command reverts to the factory default in-profile dscp-name.
Parameters
dscp-name —
Specifies the DSCP name.
Values be|cp1|cp2|cp3|cp4|cp5|cp6|cp7|cs1|cp9|af11|cp11|
af12|cp13|af13|cp15|cs2|cp17|af21|cp19|af22|cp21|
af23|cp23|cs3|cp25|af31|cp27|af32|cp29|af33|cp31|cs4|
cp33|af41|cp35|af42|cp37|af43|cp39|cs5|cp41|cp42|
cp43|cp44|cp45|ef|cp47|nc1|cp49|cp50|cp51|cp52|cp53|
cp54|cp55|nc2|cp57|cp58|cp59|cp60|cp61|cp62|cp63
queue
Syntax queue queue-id
Context config>qos>access-egress
Description
This command creates the context to modify Queue parameters associated with a particular queue.
The queue is identifiable by queue-id and FCs are mapped into the queues according to Table 31,
Forwarding Class to Queue-ID Map, on page 81.
The no form of this command is not supported
Default none
Parameters queue-id — Specifies the access egress queue-id associated with an FC according to
Table 31, Forwarding
Class to Queue-ID Map, on page 81
.
Values 1 — 8
To Next Page
Loading...
Need help?
General
