7210 SAS E OS Quality of Service Guide Page 401
This command enables the system to remark egress packets sent out of service egress (also known
as, access SAP egress).
When remarking is enabled, the remark policy configured in the QoS policy context is used to
determine the FC to QoS bit mapping. For example, when remarking is enabled in the sap-egress
QoS policy, the remark policy associated with sap-egress QoS policy is used to determine the FC
to Dot1p mapping to use for marking packets sent out of access SAPs.
Please refer to the remark policy that can be used to configure FC to priority bit markings in
different QoS policies associated with different service entities, in the chapter on remark policies.
For more information, see Table 48, Summary of remark policy and attachment points for 7210
SAS-K, on page 449.
The no form of the command disables remarking.
Default no remarking - Remarking is disabled by default.
scope
Syntax scope {exclusive | template}
no scope
Context config>qos>sap-egress
Description
This command configures the scope as exclusive or template. The policy’s scope cannot be
changed if the policy is applied to an interfacemultiple ports.
The no form of this command sets the scope of the policy to the default of template.
Default template
Parameters exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to one inter-
face/port. If a policy with an exclusive scope is assigned to a second interface an error message is
generated. If the policy is removed from the exclusive interface, it will become available for assignment
to another exclusive interface.
The system default policies cannot be put into the exclusive scope. An error will be generated if scope
exclusive is executed in any policies with a policy-id equal to default QoS policies are configured with
template scope. An error is generated if you try to modify the scope parameter from template to
exclusive scope on default policies.
template — When the scope of a policy is defined as template, the policy can be applied to multiple inter-
face/ports on the router.
To Next Page
Loading...
Need help?
General
