NTP 160 — Install an I-211M-K or I-211M-L indoor ONT
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 NTP 160-5
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
c On a wall (DLP 122).
Use the Wall mounting template for indoor ONT. To print the template from
this PDF:
i Under Print Range in the Print window, select Current view.
ii Under Page Handling, select None from the menu for Page Scaling.
iii Ensure the Auto-rotate and Center option is selected.
iv Under Preview: Composite, ensure the size for both the Document and
Paper are 8.5 x 11 inches (215.9 x 279.4 mm).
v Click OK.
d In a wall-mounted Just Inside enclosure (I-211M-L ONT only).
i Open the TELCO access cover on the Just Inside enclosure.
ii Secure the Just Inside enclosure to the mounting area at the subscriber
premises. Use the appropriate hardware as defined by local installation
practices. Mount the outdoor enclosure using the specified mounting
holes as shown in Figure NTP 160-3.
Note — Observe the following:
• The TELCO access cover of the enclosure must be open to access the
mounting holes used to secure the enclosure to the wall.
To Next Page
Loading...
