Alcatel-Lucent 7330 - Page 394

5 — VoIP overview
5-48 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
intercom_code_1 A set of one or more home
intercom service codes for
alerting pattern 1. This reflects
that fact that in typical dial
plans there are two equivalent
ways to dial a given service code.
This is a string. The value of this
property may include up to two
service codes separated by white
space.
The default is “*53 1153.” In XML
the length can be up to 6
characters. In TL1, the length
can be up to 5 characters
For other devices the setting is
“*53 1153” and cannot be
changed.
NYPackage
A, B, H
only
Yes, but
only one
intercom
code is
supported
TL1 using
INTERCOM
using
ent-profile-a
cccodes
CLI using
intercom
using
configure
voice ont
feat-acccode
-prof
intercom _code_2 A set of one or more home
intercom service codes for
alerting pattern 2. This reflects
that fact that in typical dial
plans there are two equivalent
ways to dial a given service code.
This is a string. The value of this
property may include up to two
service codes, each up to 6
characters long, separated by
white space. The default is “*54
1154.”
For other devices the setting is
“*53 1154” and cannot be
changed.
NYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
enable_cw Indicates whether the call
waiting service is enabled. This is
a string containing a value of
“yes” or “no.” The default value
is “yes.”
YYAll Yes, enabled
if both call
waiting and
caller ID are
configured
TL1 using
CALLWAIT set
to 3 using
ent-profile-v
oipappservic
e
CLI using
call-waiting
using
configure
voice ont
voip-app-serv
ice
business_cw Indicates whether the business
group variant of the call waiting
service is enabled. This is a string
containing a value of “yes” or
“no.” The default value is “no.”
YYAll
except
package
C, D, E,
I-240W-
S ONT
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(6 of 30)