Alcatel-Lucent 7330 - Page 401

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-55
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
cid_allows_from_hd
r
A value specifying whether
information from the FROM
header may be used in providing
caller ID to the phone set.
Information from
P-Asserted-Identity header is
always used in preference to the
FROM header. This value only has
effect when no
P-Asserted-Identity information
is available. A “yes” means that
the FROM header will be used for
the caller ID if the
P-Asserted-Identity header is not
present in the INVITE message. A
“no” means that, if the
P-Asserted-Identity header is not
present, then no caller ID is
provided to the phone set. The
default value is “no”.
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
enable_caller_id The same as the
cid_allows_from_hdr parameter
All lines of I-240W-S ONT should
be configured the same.
YYPackage
C, D, E,
F, G,
and
I-240W-
S ONT
No, value is
derived
from
FTP/default
line profile.
N/A
ansi_caller_id_ext_d
igits
Specifies the number of caller ID
digits displayed. Only displayed
for GSIP v4.6 and later software.
By default (false) the number of
digits displayed is 10. If set to
true, the number digits displayed
is extended up to 20.
This parameter takes effect only
if the enable_etsi parameter is
disabled (set to false).
YYPackage
A, B, H
only
Does not
apply on
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
allow_unmatched_n
otify
This parameter governs behavior
to allow a NOTIFY with full dialog
headers (indicating that they are
part of a dialog) to be accepted
by the ONT that does not match
a known SUBSCRIBE dialog. The
contents of such an unmatched
NOTIFY will be ignored. The
default is “no”, meaning that a
NOTIFY with full dialog headers
must match a known SUBSCRIBE
dialog or a 481 error will result.
If the parameter is set to yes, the
contents of such an unmatched
NOTIFY will be ignored.
This parameter should not be set
to “yes” if implicit NOTIFY
messages are expected from the
softswitch (for example, no
SUBSCRIBE is performed).
For other devices, the value is no
and cannot be changed.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(13 of 30)