Alcatel-Lucent 7330 - Page 402

5 — VoIP overview
5-56 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
rfc2833_symmetric This parameter governs the SDP
offer/answer processing related
to the payload type to use with
RFC2833. If this parameter is set
to “yes”, then it means that the
same payload types will be used
for both send and receive
RFC2833 packets. The payload
type to be used will be based on
the SDP offer or answer from the
ONT. If this parameter is set to
“no” then the payload types to
be used for send and receive
RFC2833 packets are set
according to the rules in RFC3264
section 5.
If this parameter is set to
“far_end_symmetry”, the same
payload type will be sent for
both send and receive RFC2833
packets. The payload type to be
used will be based on the SDP
offer or answer received from
the far end of the call. The
default is “no”
All lines of I-240W-S ONT should
be configured the same.
YYAll No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(14 of 30)