Alcatel-Lucent 7330 - Page 407

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-61
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
etsi_ch_merge This parameter contains the
value of the consult call service
option code which is used to
merge two sessions to a 3-way
call with mixing in the ONT. If
this property is not configured or
is configured to contain the
empty string, the ONT disables
this functionality.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or
'#'. An invalid value causes the
ONT to act as if this parameter
was not configured. This
parameter only has meaning if
the enable_esti parameter is set
to “yes”. The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_3wc_split This parameter contains the
service code that takes a 3wc to
a consult call state in the ETSI
mode. If this parameter is not
configured or is configured to
contain the empty string, the
ONT disables the split call
operation for the line in
question.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or
'#'. An invalid value causes the
ONT to act as if this parameter
was not configured. This
parameter only has meaning if
the enable_esti parameter is set
to “yes”. The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(19 of 30)