Alcatel-Lucent 7330 - Page 408

5 — VoIP overview
5-62 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
etsi_cw_release This parameter contains the
service code used to release the
active session and resume the
held call as a two way call ending
the call waiting state. If this
parameter is not configured or is
configured to contain the empty
string, the ONT disables the
release active session operation
for the line in question.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or
'#'. An invalid value causes the
ONT to act as if this parameter
was not configured. This
parameter only has meaning if
the enable_esti parameter is set
to “yes”. The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_cw_toggle This parameter contains the
service code to be used to toggle
between sessions during call
waiting. If this parameter is not
configured or is configured to
contain the empty string, the
ONT disables the toggle session
operation for the line in
question.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or
'#'. An invalid value causes the
ONT to act as if this parameter
was not configured. This
parameter only has meaning if
the enable_esti parameter is set
to “yes”. The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(20 of 30)