6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-59
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
3 Enable one of the following radio buttons to set the Mode of the SLID:
• Volatile—In volatile mode, the SLID at the ONT returns to its default value
after the ONT is powered off and on. A volatile SLID is always delivered to the
P-OLT in the proprietary mode, which uses the proprietary PLOAM message.
• Permanent—In permanent mode, the SLID at the ONT is stored in non-volatile
mode, and is delivered to the P-OLT in proprietary mode, which uses the
proprietary PLOAM message. A non-volatile SLID retains its configured value
after the ONT is powered off and on.
• Registration—In registration mode, the SLID at the ONT is stored in
non-volatile mode, and is delivered to the P-OLT in registration ID mode, which
uses the password PLOAM message defined in G.984.3. A non-volatile SLID
retains its configured value after the ONT is powered off and on.
4 Enable one of the following radio buttons to set the String format:
• Hexadecimal—20 characters of 0 to 9 and usually a to f or, A to F, with zeroes
appended to a length of 20 characters
• Alphanumeric—up to 10 ASCII characters
5 Type the SLID in the SLID Value box.
6 Click on the Apply button to apply the SLID to the ONT. The Set SLID dialog box
opens, as shown in Figure 6-36.
Figure 6-36 Set SLID dialog box
7 Click on Yes to set the SLID to its new value.
The status bar displays the message “The slid setting has been applied!”.
8 Connect the PON optical cable to the ONT.
Note — The default value is alphanumeric.
To Next Page
Loading...
