NTP 136 — Install an I-011G-A, I-011G-B, I-110G-A, or I-111G-A indoor ONT
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 NTP 136-3
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Procedure
Use this procedure to install an I-011G-A, I-011G-B, I-110G-A, or I-111G-A indoor ONT.
1 Prepare the cables at the site where the ONT will be installed (DLP 100). Locate
any missing cables and route them to the ONT as per local practices. Also, locate
the power source where the power converter will be installed.
2 Place the ONT unit:
a On a flat surface, such as a desk, resting horizontally; go to step 3.
Figure NTP 136-1 shows the ONT in this position.
Figure NTP 136-1: Horizontal I-011G-A indoor ONT
b In a stand.
i Snap the ONT into the channels built into the stand, ensuring it is
securely held.
ii Place the stand and ONT vertically on a flat surface. Figure NTP 136-2
shows the ONT and stand.
VOICE
LAN 4
LAN 3
LAN 2
LAN
ALARM
WA
N
VOICE
POWER
20425
VIDEO
To Next Page
Loading...
