Displaying IPMSv6 Configurations and Statistics Configuring IP Multicast Switching
page 42-42 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Displaying IPMSv6 Configurations and Statistics
Alcatel-Lucent’s IPv6 Multicast Switching (IPMSv6) show commands provide tools to monitor IPMSv6
traffic and settings and to troubleshoot problems. These commands are described below:
If you are interested in a quick look at IPMSv6 groups on your switch you could use the
show ipv6 multicast group command. For example:
-> show ipv6 multicast group
Total 3 Groups
Group Address Source Address VLAN Port Mode Static Count Life
----------------+---------------+-----+-----+--------+-------+------+-----
ff05::5 :: 1 2/1 exclude no 1 145
ff05::6 3333::1 1 2/1 exclude no 1 242
ff05::9 :: 1 2/13 exclude yes 0 0
Note. See the “IPv6 Multicast Switching Commands” chapter in the OmniSwitch CLI Reference Guide for
complete documentation on IPMS show commands.
show ipv6 multicast Displays the general IPv6 Multicast switching and routing configuration
parameters on a switch.
show ipv6 multicast group Displays all detected multicast groups that have members. If you do not
specify an IPv6 address, then all multicast groups on the switch will be
displayed.
show ipv6 multicast neighbor Displays all neighboring IPv6 multicast routers.
show ipv6 multicast querier Displays all IPv6 multicast queriers.
show ipv6 multicast forward Displays the IPMSv6 multicast forwarding table. If you do not specify a
multicast group IPv6 address, then the forwarding table for all multicast
groups will be displayed.
show ipv6 multicast source Displays the IPMSv6 multicast source table. If you do not specify a
multicast group IPv6 address, then the source table for all multicast
groups will be displayed.
show ipv6 multicast tunnel Display the IPv6 multicast switch and routing tunneling table entries
matching the specified IPv6 multicast group address, or all the entries if
no IPv6 multicast address is specified.
To Next Page
Loading...
