RIP Specifications Configuring RIP
page 28-2 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
RIP Specifications
RIP Defaults
The following table lists the defaults for RIP configuration through the ip rip command.
RFCs Supported RFC 1058–RIP v1
RFC 2453–RIP v2
RFC 1722–RIP v2 Protocol Applicability Statement
RFC 1724–RIP v2 MIB Extension
Platforms Supported OmniSwitch 6400, 6800, 6850, 6855, and 9000
Maximum Number of RIP Peers
(Note: This max value was not included in
Specs table prior to 6.3.3.)
10 (OmniSwitch 6400)
Maximum Number of RIP Interfaces
(Note: This max value was not included in
Specs table prior to 6.3.3.)
10 (OmniSwitch 6400)
Maximum Number of RIP Routes 2048
(Note: The “2048” value was previously documented,
however, the 6.3.3 Porting SFS specifies 1K for OS6850
and “NA” for OS6400. What values should be used?)
Description Command Default
RIP Status ip rip status disable
RIP Forced Hold-Down Interval ip rip force-holddowntimer 0
RIP Update Interval ip rip update-interval 30 seconds
RIP Invalid Timer ip rip invalid-timer 180 seconds
RIP Garbage Timer ip rip garbage-timer 120 seconds
RIP Hold-Down Timer ip rip holddown-timer 0
RIP Interface Metric ip rip interface metric 1
RIP Interface Send Version ip rip interface send-version v2
RIP Interface Receive Version ip rip interface recv-version both
RIP Host Route ip rip host-route enable
RIP Route Tag ip rip host-route 0
To Next Page
Loading...
