Port Assignment Specifications Assigning Ports to VLANs
page 6-2 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Port Assignment Specifications
Note that the maximum limit values provided in the following Specifications table are subject to available
system resources:
Port Assignment Defaults
IEEE Standards Supported 802.1Q–Virtual Bridged Local Area Networks
802.1D–Media Access Control Bridges
Platforms Supported OmniSwitch 6400, 6800, 6850, 6855, and 9000
Maximum VLANs per switch 4094 (based on switch configuration and available
resources).
Maximum VLAN port associations (VPA)
per switch
32768
Maximum 802.1Q VLAN port associations
per switch
2500 (OmniSwitch 6400)
Switch ports eligible for port mobility. Untagged Ethernet and gigabit Ethernet ports that are
not members of a link aggregate.
Switch ports eligible for dynamic VLAN
assignment.
Mobile ports.
Switch ports eligible for static VLAN
assignment.
Non-mobile (fixed) ports.
Mobile ports.
Uplink ports.
10 gigabit ports.
Link aggregate of ports.
Parameter Description Command Default
Configured default VLAN vlan port default All ports initially associated
with default VLAN 1.
Port mobility vlan port mobile Disabled
Bridge mobile port traffic that
doesn’t match any VLAN rules on
the configured default VLAN
vlan port default vlan Disabled
Drop mobile port dynamic VLAN
assignments when learned mobile
port traffic that triggered the assign-
ment ages out
vlan port default vlan restore Enabled
Enable Layer 2 authentication on the
mobile port
vlan port authenticate Disabled
Enable 802.1x port-based access
control on a mobile port
vlan port 802.1x Disabled
To Next Page
Loading...
