Configuring MPLS Quick Steps for Configuring MPLS
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 10-5
->show router ldp status
LDP Status for LSR ID 10.10.0.7
Admin State: Up, Oper State: Up,
Created at: 03/25/2009 16:08:06, Up Time: 0d
18:38:14,
Last Change: 03/25/2009 16:08:06, Tunn Down Damp Time (sec): N/A,
Import Policies: None, Export Policies: None,
Active Adjacencies: 2, Active Sessions: 2,
Active Interfaces: 1, Inactive Interfaces: 0,
Active Peers: 1, Inactive Peers: 0,
Addr FECs Sent: 1, Addr FECs Recv: 2,
Serv FECs Sent: 1, Serv FECs Recv: 1,
Attempted Sessions: 0,
No Hello Err: 0, Param Adv Err: 0,
Max PDU Err: 0, Label Range Err: 0,
Bad LDP Id Err: 0, Bad PDU Len Err: 0,
Bad Mesg Len Err: 0, Bad TLV Len Err: 0,
Malformed TLV Err: 0, Keepalive Expired Err: 0,
Shutdown Notif Sent: 0, Shutdown Notif Recv: 0
See the “Static LSP and FRR Commands” chapter and the “Label Distribution Protocol Commands” chap-
ter in the OmniSwitch CLI Reference Guide for information about the fields in the above displays.
Quick Steps for Configuring LDP
An LDP interface is required on each router that will participate in the MPLS LSP. The following steps
provide a quick tutorial for configuring LDP interfaces:
1 Configure LDP support on an existing IP interface using the configure router ldp interface-parame-
ters interface command. For example:
-> configure router ldp interface-parameters interface vlan-10
Note. Optional. When an LDP interface is created, global default parameter values are applied to that
interface. To verify the interface configuration use the show router ldp interface command. For example:
->show router ldp interface
LDP Interfaces
Interface Adm Opr Hello Hold KA KA Transport
Factor Time Factor Timeout Address
--------------------------------+---+----+------+-----+------+-------+---------
vlan-30 Up Up 3 15 3 30 System
No. of Interfaces: 1
->show router ldp interface detail
LDP Interfaces (Detail)
Interface "vlan-30"
Admin State: Up, Oper State: Up,
To Next Page
Loading...
