Configuring EFM (LINK OAM) LINK OAM Defaults
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 16-3
LINK OAM Defaults
The following table shows LINK OAM default values.
Parameter Description Command Default Value/Comments
Multiple PDU count assigned for
event notifications.
efm-oam multiple-pdu-count 3
Maximum time period for which a
LINK OAM port shall wait for a
hello message from its peer before
resetting a discovery session.
efm-oam port keepalive-interval 5 seconds
Time interval (in seconds) by which
the information OAMPDUs are
transmitted out of an LINK OAM
enabled port.
efm-oam port hello-interval 1 second
Propagate local event notifications
to the remote peer.
efm-oam port propagate-events critical event - enabled
dying-gasp event - enabled.
The threshold, window frame values
and notify status for errored frame
period events.
efm-oam errored-frame-period threshold_symbols - 1 frame
error
window_frames - Depends on
port types.
notify status - enable
The threshold, window, and notify
status for errored frame events.
efm-oam errored-frame threshold_symbols - 1 frame
error
window_seconds - 1 second
notify status - enable
The threshold, window and notify-
status for errored-frame-seconds-
summary on a port.
efm-oam errored-frame-sec-
onds-summary
threshold_symbols - 1 errored
frame second
window_seconds - 60 seconds.
notify status - enable
The number of frames sent by the
current LINK OAM port to the
MAC address of the remote port, the
delay between the frames sent, and
whether or not to start the ping oper-
ation.
efm-oam port l1-ping number - 5 frames
milliseconds - 1000
To Next Page
Loading...
