OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 29-1
29 Configuring RDP
Router Discovery Protocol (RDP) is an extension of ICMP that allows end hosts to discover routers on
their networks. This implementation of RDP supports the router requirements as defined in RFC 1256.
In This Chapter
This chapter describes the RDP feature and how to configure RDP parameters through the Command Line
Interface (CLI). CLI commands are used in the configuration examples; for more details about the syntax
of commands, see the OmniSwitch CLI Reference Guide.
The following procedures are described:
• “Enabling/Disabling RDP” on page 29-8.
• “Creating an RDP Interface” on page 29-8.
• “Specifying an Advertisement Destination Address” on page 29-9.
• “Defining the Advertisement Interval” on page 29-9.
• “Setting the Advertisement Lifetime” on page 29-10.
• “Setting the Preference Levels for Router IP Addresses” on page 29-10.
• “Verifying the RDP Configuration” on page 29-11.
To Next Page
Loading...
