Verifying the Port Mapping Configuration Configuring Port Mapping
page 7-6 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
In the above example topology:
• Ports 2/1 and 2/2 on Switch A do not interact with each other and do not interact with the ports on
Switch B.
• Ports 2/1, 2/2, and 3/1 on Switch B interact with all the ports of the network except with ports 2/1 and
2/2 on Switch A.
• Ports 2/1 and 2/2 on Switch D do not interact with each other but they interact with all the user ports on
Switch A except 3/1, 3/2, and 3/3. They also interact with all the ports on Switch B and Switch C.
• Ports 3/1, 3/2, and 2/1 on Switch C can interact with all the user ports on the network except 3/1, 3/2,
and 3/3 on Switch A.
Example Port Mapping Configuration Steps
The following steps provide a quick tutorial that configures the port mapping session shown in the
diagram on page 7-5.
1 Configure session 1 on Switch A in the unidirectional mode using the following command:
-> port mapping 1 unidirectional
2 Create two port mapping sessions on Switch A using the following commands:
-> port mapping 1 user-port 2/1-2 network-port 1/1-2
-> port mapping 2 user-port 3/1-3 network-port 1/3
3 Enable both the sessions on Switch A using the following commands:
-> port mapping 1 enable
-> port mapping 2 enable
Similarly, create and enable a port mapping session 1 on Switch D by entering the following commands:
-> port mapping 1 user-port 2/1-2 network-port 1/1
-> port mapping 1 enable
Verifying the Port Mapping Configuration
To display information about the port mapping configuration on the switch, use the show commands listed
below:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show port mapping status Displays the status of one or more port mapping sessions.
show port mapping Displays the configuration of one or more port mapping sessions.
To Next Page
Loading...
