Configuring MPLS MPLS Defaults
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 10-3
MPLS Defaults
The following table shows the default settings of the configurable LDP-based MPLS parameters.
Parameter Description Command Default Value/Comments
MPLS status for the switch.
configure router mpls shutdown Enabled
LDP status for the switch.
configure router ldp shutdown Enabled
Default hello (hold) timeout and hello
interval for all LDP interfaces on the
switch.
configure router ldp interface-
parameters hello
15 second hello timeout
3 second factor value
5 second hello interval
Default keepalive timeout and kee-
palive interval for all LDP interfaces
on the switch.
configure router ldp interface-
parameters keepalive
30 second keepalive timeout
3 second factor value
10 second keepalive interval
Transport address used to set up LDP
TCP sessions.
configure router ldp interface-
parameters transport-address
System (Loopback0) IP
address
Global hello (hold) timeout and hello
interval for targeted LDP sessions.
configure router ldp targeted-
session hello
45 second hello timeout
3 second factor value
15 second hello interval
Global keepalive timeout and kee-
palive interval for targeted LDP ses-
sions.
configure router ldp targeted-
session keepalive
40 second keepalive timeout
4 second factor value
10 second keepalive interval
Graceful restart helper status.
configure router ldp graceful-
restart-helper
Disabled
The amount of time that neighboring
LDP routers should wait before
attempting to reconnect to the LDP
router after a graceful restart.
configure router ldp reconnect-
time
120 seconds
The amount of time that the LDP
router retains its MPLS forwarding
state after a graceful restart.
configure router ldp fwd-state-
holding-time
120 seconds
The amount of time the LDP router
retains stale MPLS label-FEC bind-
ings received from a neighboring
LDP router as the result of a graceful
restart process.
configure router ldp maximum-
recovery-time
120 seconds
The amount of time the LDP router
will wait for a neighboring router to
re-establish an LDP session.
configure router ldp neighbor-
liveness-time
120 seconds
To Next Page
Loading...
