Verifying the LINK OAM Configuration Configuring EFM (LINK OAM)
page 16-12 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Verifying the LINK OAM Configuration
To display information about LINK OAM on the switch, use the show commands listed below:
show efm-oam configuration Displays the global LINK OAM configuration.
show efm-oam port Displays the status of LINK OAM on all the ports in the system,
along with other relevant information such as OAM mode, opera-
tional status and loopback status of the port.
show efm-oam port detail Displays the LINK OAM configuration and other related parameters
for a port.
show efm-oam port statistics Displays the LINK OAM statistics on a port, or a range of ports or
on all ports.
show efm-oam port remote detail Displays the LINK OAM configuration and details of the related
parameters of the remote port.
show efm-oam port history Displays the log of events that have occurred on a port. Use this
command to display specific event logs on a port.
show efm-oam port l1-ping detail Displays the frames lost during a loopback session.
To Next Page
Loading...
