Configuring VPLS Services Configuring VPLS
page 11-16 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Consider the following when configuring customer accounts:
• The description, contact name, and phone number are not set for the account by default.
• A default customer account (customer 1) already exists in the switch configuration. This account is
automatically assigned to a service when the service is created.
To verify customer account information, use the show service customer command. For example:
-> show service customer
Customer
Customer-ID 1
Description: Default customer
Customer-ID 129
Contact: VJ Smith,
Description: Customer 129,
Phone: 100-232-4407
Customer-ID 1234
Contact: John Clark,
Description: Customer 1234,
Phone: 100-434-1248
Total Customers : 3
Configuring Service Distribution Points (SDPs)
The following tasks are required to configure an SDP:
• Determine the originating router for the SDP tunnel.
• Create a locally unique SDP ID number.
• Obtain the system IP address of the originating and far-end (endpoint) router.
• Enable Label Distribution Protocol (LDP) Label Switched Paths (LSPs) or assign static LSPs to the
SDP ID.
SDP Configuration Guidelines
Consider the following when configuring SDPs:
• MPLS is the supported SDP encapsulation type with this implementation. GRE encapsulation is not
supported at this time. As a result, configuring the encapsulation type is not necessary; MPLS is used
by default.
• The SDP uses the system (Loopback0) IP address to identify the far-end router.
Commands Used for ...
configure service customer description Providing additional information about the account.
configure service customer contact Adding a customer contact name to the account.
configure service customer phone Adding a contact phone number to the account.
To Next Page
Loading...
