Configuring Ethernet Ports Verifying Ethernet Port Configuration
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 1-31
Verifying Ethernet Port Configuration
To display information about Ethernet port configuration settings, use the show commands listed in the
following table:
show interfaces flow control Displays interface flow control wait time settings in nanoseconds.
show interfaces pause Displays the flow control pause configuration for switch interfaces.
show interfaces e2e-flow-vlan Displays the flow control VLAN configuration for the switch.
show interfaces Displays general interface information, such as hardware, MAC
address, input and output errors.
show interfaces accounting Displays interface accounting information.
show interfaces counters Displays interface counters information.
show interfaces counters
errors
Displays interface error frame information for Ethernet and Fast
Ethernet ports.
show interfaces collisions Displays collision statistics information for Ethernet and Fast Ethernet
ports.
show interfaces status Displays line status information.
show interfaces port Displays port status information.
show interfaces ifg Displays inter-frame gap values.
show interfaces flood rate Displays peak flood rate settings.
show interfaces traffic Displays interface traffic statistics.
show interfaces capability Displays autonegotiation, flow, speed, duplex, and crossover settings.
show interfaces hybrid Displays general interface information (e.g., hardware, MAC address,
input errors, output errors) for combo ports.
show interfaces hybrid status Displays line status information for combo ports.
show interfaces hybrid flow
control
Displays interface flow control wait time settings in nanoseconds for
combo ports.
show interfaces hybrid pause Displays the flow control pause configuration for combo ports.
show interfaces hybrid
capability
Displays autonegotiation, flow, speed, duplex, and crossover settings
for combo ports.
show interfaces hybrid
accounting
Displays interface accounting information (e.g., packets received/trans-
mitted, deferred frames received) for combo ports.
show interfaces hybrid
counters
Displays interface counters information (e.g., unicast, broadcast, multi-
cast packets received/transmitted) for combo ports.
show interfaces hybrid
counters errors
Displays interface error frame information (e.g., CRC errors, transit
errors, receive errors) for combo ports.
show interfaces hybrid
collisions
Displays interface collision information (e.g., number of collisions,
number of retries) for combo ports.
show interfaces hybrid traffic Displays interface traffic statistics for combo ports.
show interfaces hybrid port Displays interface port status (up or down) for combo ports.
show interfaces hybrid flood
rate
Displays interface peak flood rate settings for combo ports.
show interfaces hybrid ifg Displays interface inter-frame gap values for combo ports.
To Next Page
Loading...
