Port Mirroring Diagnosing Switch Problems
page 45-22 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Configuring Remote Port Mirroring
This section describes the steps required to configure Remote Port Mirroring between Source, Intermedi-
ate, and Destination switches.
The following diagram shows an example of a Remote Port Mirroring configuration:
Remote Port Mirroring Example
Configuring Source Switch
Follow the steps given below to configure the Source Switch:
-> vlan 1000
-> vlan 1000 stp disable
-> port mirroring 8 source 1/1
-> port mirroring 8 destination 1/2 rpmir-vlan 1000
Configuring Intermediate Switch
Follow the steps given below to configure all the Intermediate Switches:
-> vlan 1000
-> vlan 1000 stp disable
-> vlan 1000 802.1q 2/1
-> vlan 1000 802.1q 2/2
Enter the following QoS commands to override source learning:
-> policy condition c_is1 source vlan 1000
-> policy action a_is1 redirect port 2/2
Local MTP
Source switch
Destination
switch
Intermediate
switch
RPMir
VLAN
Source
Port
Destination Port
1/1
1/2
2/1
2/2
3/1
- 1000
3/2
To Next Page
Loading...
