Alcatel-Lucent OmniSwitch 6850-48 - Verifying the Spanning Tree Configuration

Configuring Spanning Tree Parameters Verifying the Spanning Tree Configuration
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 13-43
Verifying the Spanning Tree Configuration
To display information about the Spanning Tree configuration on the switch, use the show commands
listed below:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show spantree and show spantree ports commands is also
given in “Example Network Configuration Steps” on page 13-41.
bridge rrstp ring vlan-tag Displays VLAN Spanning Tree information, including parameter values
and topology change statistics.
show spantree ports Displays Spanning Tree information for switch ports, including parame-
ter values and the current port state.