Alcatel-Lucent OmniSwitch 6850-48 - Verifying the VPLS Configuration

Verifying the VPLS Configuration Configuring VPLS
page 11-32 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Verifying the VPLS Configuration
You can use CLI show commands to display the current configuration and statistics of VPLS service enti-
ties on a switch. These commands include the following:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show service port Displays the access port configuration.
show service l2profile Displays the Layer 2 profiles configured for the switch.
show service customer Displays the customer account configuration.
show service sdp Displays the SDP configuration for the switch.
show service id all Displays detailed configuration information about the specified ser-
vice ID, including the SDP and SAP configuration associated with
the service.
show service sap-using Displays the Service Access Point (SAP) usage for the switch.
show service sdp-using Displays the Service Distribution Point (SDP) usage for the switch.
show service egress-label Displays the services that are using a specific egress label or a range
of egress labels.
show service ingress-label Displays the services that are using a specific ingress label or a range
of ingress labels.
show service fdb-info Displays forwarding database (FDB) information for the router.