Configuring UDLD Configuring UDLD
page 17-8 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
-> no udld port 4/6 echo-wait-timer
The following command resets the timer for multiple ports:
-> no udld port 1/8-21 echo-wait-timer
Note that when a timer is reset, the default value of 8 seconds is set.
Clearing UDLD Statistics
To clear the UDLD statistics, use the clear udld statistics port command. For example, to clear the statis-
tics for port 4 on slot 1, enter:
-> clear udld statistics port 1/4
To clear the UDLD statistics on all the ports, enter:
-> clear udld statistics
Recovering a Port from UDLD Shutdown
To bring a port out of the shutdown state, use the interfaces clear-violation-all command. For example, to
bring port 5 on slot 1 out of the shutdown state, enter:
-> interfaces 1/5 clear-violation-all
To bring multiple ports out of the shutdown state, enter:
-> interfaces 5/5-10 clear-violation-all
To Next Page
Loading...
