Configuring VPLS VPLS Defaults
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 11-3
VPLS Defaults
Parameter Description Command Default Value/Comments
MPLS status for the switch.
configure router mpls shutdown Enabled
LDP status for the switch.
configure router ldp shutdown Enabled
Customer (subscriber) account
configure service customer create Customer 1 (default
account assigned to new
services)
Service Distribution Point (SDP)
administrative status when the
SDP is created.
configure service sdp shutdown Disabled
LDP-signaled LSPs for the SDP configure service sdp ldp Disabled
Auto-label signaling for the SDP configure service sdp signaling Enabled (Targeted LDP)
Override the advertised VC MTU
value with the service MTU value.
configure service sdp adv-mtu-
override
Disabled
The administrative MTU value for
the SDP
configure service sdp path-mtu 0 (value is derived from
the corresponding tunnel)
VPLS administrative status when
the service is created
configure service vpls shutdown Disabled
Default VC ID for each end of the
MPLS tunnel for the service.
configure service vpls def-mesh-vc-id VPLS service ID is used
as the default VC ID
MAC flush message sent on port
or Service Access Point (SAP)
failure.
configure service vpls send-flush-on-
failure
Disabled
The service MTU configure service vpls service-mtu 1514
VPLS mesh-SDP binding status
when the binding is created
configure service vpls mesh-sdp
shutdown
Disabled
Layer 2 profile for specifying how
control packets are process on
access (customer-facing) ports.
configure service l2profile def-access-profile:
stp, gvrp = tunnel
802.3ad = peer
802.1x, 802.1ab = discard
amap = discard
Service mode for ports when
MPLS is enabled for the switch.
configure service port mode access Network port
Default profile applied to access
ports
configure service port l2profile def-access-profile
Access port encapsulation type configure service port encap-type null (only one SAP is
allowed on the port)
SAP administrative status when
the SAP is created
configure service vpls sap shutdown Disabled
SAP trust mode for packets
ingressing on access ports.
configure service vpls sap trusted Trusted (tagged)
Priority 0 (untagged)
To Next Page
Loading...
