Alcatel-Lucent OmniSwitch 6850-48 - Verifying the MPLS Configuration

Configuring MPLS Verifying the MPLS Configuration
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 10-41
Verifying the MPLS Configuration
To display information about the LDP-based MPLS configuration and status for the switch, use the show
commands listed in the following table:
In addition to using the above show commands to verify the MPLS configuration, the following
commands are available to verify MPLS Label Switched Paths (LSPs):
For more information about the use and resulting displays form all of the above commands, see the
Omniswitch CLI Reference Guide.
show router mpls status Displays the status and other configuration information for the MPLS
instance.
show router ldp status Displays the status and other configuration information for the LDP
instance.
show router ldp interface Displays the LDP interface configuration for the switch.
show router ldp parameters Displays the global LDP parameter values for the switch.
show router ldp session Displays information about LDP sessions.
show router ldp peer Displays information about LDP peers.
show router ldp discovery Displays the discovery status of the LDP Hello adjacencies between the
local router and LDP peers.
show router ldp bindings Displays the contents of the MPLS Label Information Base (LIB).
show router mpls static-lsp Displays the static LSP configuration for the switch.
show router mpls interface Displays the MPLS interface configuration for the switch.
show router mpls label Displays the MPLS labels that are exchanged.
show router mpls label-range Displays the MPLS label ranges, which includes the label type, start and
end label values, aging, and the number of labels available.
oam lsp-ping Performs an Operation Administration and Maintenance (OAM) in-
band connectivity test for an existing MPLS LSP.
oam lsp-trace Performs an OAM traceroute for an existing MPLS LSP.