Alcatel-Lucent OmniSwitch 6850-48 - VLAN Specifications; VLAN Defaults

VLAN Specifications Configuring VLANs
page 4-2 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
VLAN Specifications
Note that the maximum limit values provided in the following Specifications table are subject to available
system resources:
VLAN Defaults
RFCs Supported 2674 - Definitions of Managed Objects for Bridges
with Traffic Classes, Multicast Filtering and Virtual
LAN Extensions
IEEE Standards Supported 802.1Q - Virtual Bridged Local Area Networks
802.1D - Media Access Control Bridges
Platforms Supported OmniSwitch 6400, 6800, 6850, 6855, and 9000
Maximum VLANs per switch 4094
Maximum VLAN port associations (VPA)
per switch
32768
Maximum 802.1Q VLAN port associations
per switch
2500 (OmniSwitch 6400)
Maximum IP router interfaces per switch 4094
128 IP (OmniSwitch 6400)
Maximum IP router interfaces per VLAN 8
Maximum Spanning Tree VLANs per switch 252
Maximum IPX router interfaces per switch 256
Maximum authenticated VLANs per switch 128
MAC Router Mode Supported Single
CLI Command Prefix Recognition All VLAN management commands support prefix
recognition. See the “Using the CLI” chapter in the
OmniSwitch AOS Release 6 Switch Management
Guide for more information.
Parameter Description Command Default
VLAN identifier (VLAN ID) vlan VLAN 1 predefined on each
switch.
VLAN administrative state vlan Enabled
VLAN description vlan name VLAN identifier (VLAN ID)
VLAN Spanning Tree state vlan stp Enabled (Disabled if VLAN
count exceeds 254)
VLAN mobile tag status vlan mobile-tag Disabled
VLAN IP router interface ip interface VLAN 1 router interface.
VLAN IPX router interface vlan router ipx No router interface defined.
VLAN authentication status vlan authentication Disabled