Configuring Spanning Tree Parameters Multiple Spanning Tree (MST) Region Defaults
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 13-5
Multiple Spanning Tree (MST) Region Defaults
Although the following parameter values are specific to MSTP, they are configurable regardless of which
mode (flat or 1x1) or protocol is active on the switch.
Ring Rapid Spanning Tree Defaults
The following parameter value is specific to RRSTP and is only configurable when the flat mode is active
on the switch.
Parameter Description Command Default
The MST region name bridge mst region name blank
The revision level for the MST region bridge mst region revision
level
0
The maximum number of hops autho-
rized for the region
bridge mst region max
hops
20
The number of Multiple Spanning Tree
Instances (MSTI)
bridge msti 1 (flat mode instance)
The VLAN to MSTI mapping bridge msti vlan All VLANs are mapped to the
Common Internal Spanning
Tree (CIST) instance
Parameter Description Command Default
Ring Rapid Spanning Tree Protocol sta-
tus
bridge rrstp Disabled
Number of rings bridge rrstp ring 0
Ring status bridge rrstp ring
bridge rrstp ring status
Disabled
To Next Page
Loading...
