Alcatel-Lucent OmniSwitch 6850-48 - Verifying the VLAN Stacking Configuration

Verifying the VLAN Stacking Configuration Configuring VLAN Stacking
page 9-24 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Verifying the VLAN Stacking Configuration
You can use CLI show commands to display the current configuration and statistics of service-based
VLAN Stacking on a switch. These commands include the following:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show ethernet-service command is also given in “Quick
Steps for Configuring VLAN Stacking” on page 9-9.
show ethernet-service mode Displays the active VLAN Stacking mode for the switch.
show ethernet-service vlan Displays the SVLAN configuration for the switch.
show ethernet-service Displays the VLAN Stacking service configuration for the switch.
show ethernet-service sap Displays the VLAN Stacking service access point (SAP) configura-
tion for the switch.
show ethernet-service port Displays configuration information for VLAN Stacking ports.
show ethernet-service nni Displays configuration information for NNI port parameters.
show ethernet-service uni Displays profile associations for UNI ports.
show ethernet-service uni-profile Displays UNI profile attribute values.
show ethernet-service sap-profile Displays SAP profile attribute values.