Configuring the Server Farm Configuring Server Load Balancing
page 44-16 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Adding the Microsoft Loopback Adapter Driver
This section describes how to add Microsoft’s loopback adapter to Windows NT servers (see “Adding the
Loopback Adapter Driver to a Windows NT Server” on page 44-16) and Windows 2000 servers (see
“Adding the Loopback Adapter Driver to a Windows 2000 Server” on page 44-18).
Adding the Loopback Adapter Driver to a Windows NT Server
Follow the steps below to add the Microsoft loopback adapter driver to a Windows NT server.
1 Open the Control Panel window by clicking the Start button and then selecting Settings.
2 Double-click the Network icon in the Control Panel window.
3 Click the Adapters tab in the Network window.
4 Click the Add... button.
Double-click
the “Network”
icon.
Click the
“Adapters”
tab.
Click the “Add...”
button when ready.
To Next Page
Loading...
