Alcatel-Lucent OmniSwitch 6850-48 - IP Specifications; IP Defaults

Configuring IP IP Specifications
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 24-3
IP Specifications
Note that the maximum limit values provided in the following Specifications table are subject to available
system resources:
IP Defaults
The following table lists the defaults for IP configuration through the ip command.
RFCs Supported RFC 791–Internet Protocol
RFC 792–Internet Control Message Protocol
RFC 826–An Ethernet Address Resolution Protocol
2784–Generic Routing Encapsulation (GRE)
2890–Key and Sequence Number Extensions to GRE
(extensions defined are not supported)
1701–Generic Routing Encapsulation (GRE)
1702–Generic Routing Encapsulation over IPV4 Networks
2003-IP Encapsulation within IP.
Platforms Supported
IPv4
GRE/IPIP tunnels
OmniSwitch 6400, 6800, 6850, 6855, and 9000
OmniSwitch 6400, 6850, 6855, and 9000
Maximum VLANs per switch 4094
Maximum router interfaces per switch 4094 IP and 64 IPX
128 IP and 32 IPX (OmniSwitch 6400)
Maximum IP router interfaces per VLAN 8
Maximum ARP entries per switch 1K
Maximum ARP filters per switch 200
Maximum static IP routes per switch 2K
512 (OmniSwitch 6400)
Maximum number of GRE tunnel interfaces
per switch
8
Maximum number of IPIP tunnel interfaces
per switch
127 (OmniSwitch 6850, 6855, and 9000)
16 (OmniSwitch 6400)
Routing protocols supported over the tunnel
interfaces
RIP, OSPF, and BGP
Maximum number of ECMP gateways (per
static route)
4 (OS6400, OS6855)
16 (OS6850, 9000, 9000E)
Description Command Default
IP-Directed Broadcasts ip directed-broadcast off
Time-to-Live Value ip default-ttl 64 (hops)
IP interfaces ip interface VLAN 1 interface.
ARP filters ip dos arp-poison restricted-
address
0