VPLS Specifications Configuring VPLS
page 11-2 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
VPLS Specifications
*Applies to egress and ingress Label Edge Routers (LERs) only.
**Applies to transit Label Switching Routers (LSRs) only.
IETF Internet-Drafts Supported draft-ietf-bfd-base-08.txt — Bidirectional Forward-
ing Detection
draft-ietf-bfd-v4v6-1hop-08.txt — BFD for IPv4
and IPv6 (Single Hop)
RFCs Supported 3031–Multiprotocol Label Switching Architecture
3036–Label Distribution Protocol Specification
3478–Graceful Restart Mechanism for LDP.
4762–Virtual Private LAN Service (VPLS) using
LDP Signaling.
Platforms Supported OmniSwitch 9000E
Maximum number of service instances
(VPLS) per system
1024*
Maximum number of pseudo wires/VCs per
system
8K*
Maximum number of Service Access Points
(SAPs) and service bindings (virtual ports)
8192*
Maximum number of Service Distribution
Point (SDP) sessions.
32
Maximum number of LDP/Target LDP
neighbors
32*
Maximum number of LDP/Target LDP ses-
sions
32*
Maximum number of LSP tunnels (push/pop
entries)
32*
Maximum number of LSP swap entries 32**
Maximum number of static LSPs 1024
Maximum number of backup static LSPs 16
To Next Page
Loading...
