Alcatel-Lucent OmniSwitch 6850-48 - Verifying the IPX Configuration

Configuring IPX Verifying the IPX Configuration
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 33-15
Verifying the IPX Configuration
A summary of the show commands used for verifying the IPX configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show ipx interface Displays current IPX interface configuration information.
show ipx route Displays IPX routing table information.
show ipx filter Displays currently configured IPX RIP, SAP, and GNS filters.
show ipx type-20-propagation Displays the current status of Type 20 packet forwarding.
show ipx packet-extension Displays the current status of the extended RIP/SAP packet feature.
show ipx timers Displays the current RIP and SAP timer values.