Alcatel-Lucent OmniSwitch 6850-48 - In this Chapter

OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 45-1
45 Diagnosing Switch
Problems
Several tools are available for diagnosing problems that may occur with the switch. These tools include:
• Port Mirroring
• Port Monitoring
• sFlow
• Remote Monitoring (RMON) probes
• Switch Health Monitoring
Port mirroring copies all incoming and outgoing traffic from a single mirrored Ethernet port to a second
mirroring Ethernet port, where it can be monitored with a Remote Network Monitoring (RMON) probe or
network analysis device without disrupting traffic flow on the mirrored port. The port monitoring feature
allows you to examine packets to and from a specific Ethernet port. sFlow is used for measuring high
speed switched network traffic. It is also used for collecting, storing, and analyzing the traffic data. Switch
Health monitoring software checks previously configured threshold levels for the switch’s consumable
resources, and notifies the Network Monitoring Station (NMS) if those limits are violated.
In This Chapter
This chapter describes port mirroring, port monitoring, remote monitoring (RMON) probes, sFlow, and
switch health features and explains how to configure the same through the Command Line Interface (CLI).
Configuration procedures described in this chapter include:
• Creating or Deleting a Port Mirroring Session—see “Creating a Mirroring Session” on page 45-18 or
“Deleting A Mirroring Session” on page 45-21.
• Protection from Spanning Tree changes (Port Mirroring)—see “Unblocking Ports (Protection from
Spanning Tree)” on page 45-19.
• Enabling or Disabling Port Mirroring Status—see “Enabling or Disabling Mirroring Status” on
page 45-19 or “Disabling a Mirroring Session (Disabling Mirroring Status)” on page 45-19.
• Configuring Port Mirroring Direction—see “Configuring Port Mirroring Direction” on page 45-20.
• Enabling or Disabling a Port Mirroring Session—see “Enabling or Disabling a Port Mirroring Session
(Shorthand)” on page 45-20.
• Configuring a Port Monitoring Session—see “Configuring a Port Monitoring Session” on page 45-25.
• Enabling a Port Monitoring Session—see “Enabling a Port Monitoring Session” on page 45-25.