Configuring BFD Verifying the BFD Configuration
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 30-31
Verifying the BFD Configuration
To display information such as the BFD status for different session parameters and Layer 3 protocols, use
the show commands listed in the following table:
For more information about the resulting displays form these commands, see the Omniswitch CLI Refer-
ence Guide. Examples of the above commands and their outputs are given in the section “Configuring
BFD” on page 30-13.
show ip bfd-std Displays the global BFD configuration for the switch.
show ip bfd-std interfaces Displays the BFD interface configuration for the switch.
show ip bfd-std sessions Displays the BFD neighbors and session states.
show ip ospf Displays the BFD status for the OSPF protocol.
show ip ospf interface Displays the BFD status for OSPF interfaces.
show ip bgp Displays the BFD status for the BGP protocol.
show ip bgp neighbors Displays the BFD status for BGP neighbors.
show vrrp Displays the BFD status for the VRRP protocol.
show vrrp track Displays the BFD status for a track policy.
show ip route Displays the BFD status for static routes.
To Next Page
Loading...
