Static Link Aggregation Specifications Configuring Static Link Aggregation
page 22-2 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Static Link Aggregation Specifications
The table below lists specifications for static groups.
Static Link Aggregation Default Values
The table below lists default values and the commands to modify them for static aggregate groups.
Platforms Supported OmniSwitch 6400, 6800, 6850, 6855, and 9000
Maximum number of link aggregation groups 32 (per switch or a stack of switches)
Number of links per group supported 2, 4, or 8 (per switch or a stack of switches)
Range for optional group name 1 to 255 characters
CLI Command Prefix Recognition All static link aggregation configuration commands
support prefix recognition. (Static link aggregation
show commands do not support prefix recognition.)
See the “Using the CLI” chapter in the OmniSwitch
AOS Release 6 Switch Management Guide for more
information.
Parameter Description Command Default Value/Comments
Administrative State static linkagg admin state enabled
Group Name static linkagg name No name configured
To Next Page
Loading...
