OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 1-1
1 Configuring Ethernet Ports
The Ethernet software is responsible for a variety of functions that support Ethernet, Gigabit Ethernet, and
10 Gigabit Ethernet ports on OmniSwitch Series switches. These functions include
diagnostics, software loading, initialization, configuration of line parameters, gathering statistics, and
responding to administrative requests from SNMP or CLI.
In This Chapter
This chapter describes your switch’s Ethernet port parameters and how to configure them through the
Command Line Interface (CLI). CLI Commands are used in the configuration examples. For more details
about the syntax of commands, see the OmniSwitch CLI Reference Guide.
Configuration procedures described in this chapter include:
• “Setting Ethernet Parameters for All Port Types” on page 1-10
• “Setting Ethernet Parameters for Non-Combo Ports” on page 1-16
• “Setting Ethernet Combo Port Parameters” on page 1-21
• “Combo Port Application Example” on page 1-29
For information about CLI commands that can be used to view Ethernet port parameters, see the
OmniSwitch CLI Reference Guide.
To Next Page
Loading...
